Helix P Two 2-ch Amplifier

$1,750.00

In stock

Category:
Description
DescriptionFeaturesSpecifications

Plenty of power and sensitivity – the new P TWO combines two talents in an absolutely unique way. Due to its RMS output power of 2 x 490 Watts into two Ohms, this compact amplifier is able to drive even powerful subwoofers to the max. The technical design is literally predestinated for all woofers with 2 x 2 Ohms dual voice coil like the new HELIX Q subwoofers.

But despite its sheer force the P TWO is by no means a pure subwoofer amplifier. On the contrary, the Ultra HD Class D concept combines an extended frequency response above 40 kHz with high damping factor, minimal distortion and excellent signal-to-noise ratio. Therefore, this amplifier is likewise a perfect buddy for heavy-duty front speakers in audiophile system concepts.

Ultra-HD-Class-D High-Res-Audio Highlevel-Input ADEP RCA-Input Optical-Input Remmote-Control-ready Auto-Remote-Switch Active crossover Start-Stop-Capability SMD Made-in-Germany
  • “Ultra HD Class D” concept which combines the high-end sound quality of Class AB technology with the benefits of Class D amplifiers
  • Two speaker outputs with 490 Watts RMS each at 2 Ohms
  • Digital, optical signal input in SPDIF format including SPDIF Direct In switch for routing the digital input signal directly to the power stage
  • BurrBrown DA signal converter of the latest generation with a resolution of 32 Bit
  • Integrated, active crossover with highpass, lowpass, bandpass and configurable bass boost
  • Smart highlevel input with ADEP circuit
  • Cable remote control for volume adjustment
  • Compact design with low heat dissipation thanks to extraordinary efficiency

 

Special features:

Ultra HD Class D amplifier technology
Compared to conventional Class D amps, this concept achieves an extended frequency response to more than 40 kHz in combination with reduced distortion thanks to an advanced integrated feedback design. Ultra HD Class D achieves outstanding, “Class AB-like” sound quality combined with the efficiency of a Class D amplifier.

Signal converters with a native resolution of 32 Bit
The HELIX P TWO uses for the optical input a highclass DA signal converter of the latest generation with a native resolution of 32 Bit instead of the common 24 Bit. The result is an unprecedented precision in signal conversion that especially optimizes the sound quality at lower signal levels.

Smart highlevel input
The latest generation of OE car radios incorporates sophisticated possibilities of diagnosing the connected speakers. If a common amplifier will be hooked up failure messages and loss of specific features (e.g. fader function) quite often appears – but not with the P TWO. The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without loading the speaker outputs of the OE radio during high volumes unnecessarily.

Start-Stop capability
The switched power supply of the HELIX P TWO assures operation even if the battery’s voltage drops down to 6 Volts during engine crank.

Output power RMS / max.
– @ 4 Ohms2 x 280 / 560 Watts
– @ 2 Ohms2 x 490 / 980 Watts
– @ 1 Ohm
– bridged @ 4 Ohms
– bridged @ 2 Ohms
Amplifier technologyUltra HD Class D
Inputs2 x RCA / Cinch
2 x Highlevel speaker input
1 x Optical SPDIF (28 – 96 kHz)
1 x Remote In
1 x Remote control input
Input sensitivityRCA / Cinch 2 – 8 Volts
Highlevel 5 – 20 Volts
Input impedance RCA / Cinch10 kOhms
Input impedance highlevel13 Ohms
Outputs2 x Speaker output
Output voltage RCA / Cinch
Signal converter for digital inputBurrBrown 32 Bit DA converter
Frequency response10 Hz – 40,000 Hz
Bass boost0 – 9 dB / 40 Hz – 120 Hz
Highpass15 Hz – 4,000 Hz regelbar
Lowpass15 Hz – 4,000 Hz regelbar
Bandpass15 Hz – 4,000 Hz regelbar
Subsonic
Phase
Slope high- / lowpassButterworth 12 dB/Oct.
Slope subsonic / lowpass
Signal-to-noise ratio digital input105 dB (A-weighted)
Signal-to-noise ratio analog input105 dB (A-weighted)
Distortion (THD)< 0.005 %
Damping factor> 200
Operating voltage10.5 – 16 Volts (max. 5 sec. down to 6 Volts)
Idle current2400 mA
Fuse3 x 30 A LP-Mini-fuse (APS)
Additional featuresActive, adjustable crossover, bass boost, input mode switch, highlevel input with Advanced Diagnostics Error Protection (ADEP), Auto Remote switch, SPDIF Direct In switch, cable remote control for volume adjustment
Dimensions (H x W x D)50 x 260 x 190 mm /
1.97 x 10.24 x 7.48”
Additional information
Weight 8 kg
Dimensions 32 × 25 × 9 cm
Brand

Helix

Number of Channels

2 channel

Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Helix P Two 2-ch Amplifier”

Your email address will not be published. Required fields are marked *

Shipping & Delivery